OSI Security Devices OMNILOCK OM100 Series User Manual page 48

Programming in Menu Mode
Enter the three digit code ID at which you want to begin adding (you must
enter any leading zeros) or press the CL key if you are finished adding User
codes. When you have entered a valid starting ID number, the following
prompt will print:
ENDING ID (###)?
Enter the last three digit code ID that you want to add or, if you are only
adding a single User code, press the CL key and the System will accept the
starting ID number that you entered above as the ending ID number.
If you elected to add codes with the Autocode feature, a confirmation of the
codes added will print and the starting ID prompt will then reprint.
Otherwise, you will be prompted to enter the PIN for each code ID number
that you are adding. For example:
001: 4 DIGIT PIN?
The first three digits of the prompt represent the Code ID to which the PIN
will be assigned. If you are using a PIN length of 5 or 6 digits, the prompt
will reflect it accordingly. When all of the PINs have been entered, a
confirmation of the User IDs added will print and the starting ID prompt
will then reprint.
Important!
Before you can add a block of User codes, all
codes within the block must be available. If you
are not sure, first clear the block by removing all
of the codes. Another way to quickly determine
what blocks of codes are available is to verify
users without printing PINs or groups.
38