Restoring Codes; Assigning Supervisor Privileges - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Command Mode

Restoring Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To restore a code from Hold status, enter the following command sequence
while in the Command mode:
where ID is the three digit ID number of the code that you want to restore
(you must enter any leading zeros).
To indicate the result of the command, the lights will flash as follows:
Green
Green-Green
Green-Green-Green
Red

Assigning Supervisor Privileges

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
A user with Supervisor privileges can allow or restrict access by all general
users within the Supervisor's home group.
To assign Supervisor privileges to a general user, enter the following
command sequence while in the Command mode:
24
87 + ID + CL
The code is restored.
The Supervisor code has been restored.
The Manager code has been restored.
Invalid command, the code was not on hold.
88 + ID + CL