OSI Security Devices OMNILOCK OM100 Series User Manual page 64

Programming in Menu Mode
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 2-REMOVE from the Service Code Menu:
) -- SERVICE CODE MENU ---
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-TIME LIMIT (01:00)
The following prompt will print:
REMOVE SERVICE CODE?
1-YES 2-NO
Press 1-YES to remove the Service code. Otherwise, press 2-NO to abort
without removing the Service code.
If 1-YES is pressed, the following conformation will print:
SERVICE CODE REMOVED
The Service Code Menu will then reprint.
54
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT