OSI Security Devices OMNILOCK OM100 Series User Manual page 37

When you enable a group, the level of supervision for the group is
determined by the type of group. If the group contains one or more
Supervisor codes, the group's supervision will default to supervised. If there
are no Supervisor codes within the group, the group's supervision will
default to unsupervised.
The length of time you hold the CL key determines whether a Group's
supervision will be set to its default (1 green flash) or be forced to
unsupervised (2 green flashes). If you want the supervised Groups to be
unsupervised, continue to hold the CL key after the first green flash until
there are two more green flashes (approximately 2 seconds).
To enable access for a group or groups, enter the following command
sequence while in the Command mode:
91 + [ 1
where 1, 2 ,3 and 4 represent the Group number(s) you want to enable. If
you want to enable all Groups, do not enter any Group numbers.
To indicate the status of the command, the lights will flash as follows:
Green Selected Groups (or all Groups) set to Supervised.
Green-Green Selected Groups (or all Groups) fully enabled and have
unlimited access.
Red-Red Invalid Group number.
Programming in Command Mode
] ] ]
+ [ 2 + [ 3 + [ 4 ] + CL
27