Setting The Access Level - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
Reenter the new PIN for confirmation. Once the PIN has been reentered, a
confirmation of the changes made will print.
If the code length was changed, the following will print:
***ALL CODES ERASED***
MASTER CODE SET
If the code length was NOT changed, the following will print:
MASTER CODE SET
The Codes Menu will then reprint.

Setting the Access Level

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 3-ACCESS
(Master code required to set access level 4-SHUTDOWN)
Important!
Changes made to the access level will not take
effect until after you have quit the programming
session. Any changes made will remain in effect
until
overridden by the next scheduled event in the
Time Schedule.
To set the current access level, select 3-ACCESS from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
76
changed again manually, or until