Supervisor Operation - OSI Security Devices OMNILOCK OM100 Series User Manual

b) Press and hold the CL key (approximately 2 seconds) until the
green light flashes two times.
To set the access level to Lockout:
a) Press and hold the CL key (approximately 2 seconds)until
the green light flashes three times.
TIP
If the red light flashes while changing the
access level, you have paused too long
between key presses and the programming
session has ended. No programming has been
changed. Re-enter the Manager Code and try
again.

Supervisor Operation

A user with Supervisor privileges can allow or restrict access by all general
users within the Supervisor's home group.
To allow access to all General User codes within a Supervisor's home group,
set the group to unsupervised as follows: enter the Supervisor code then
press and hold the CL key until the green light flashes twice.
To deny access to all General User codes within a Supervisor's home group,
set the group to supervised as follows: enter the Supervisor code then press
and hold the CL key until the red light flashes twice.
Tip
If the System repeatedly denies access to a
valid General User code, the user's group may
be restricted by a Supervisor code.
Operation and Indicators
15