Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used
1-USER 2-SERVICE 3-AUDIT
Next, select 4-HOLD from the Service Code Menu:
)
-- SERVICE CODE MENU ---
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-TIME LIMIT (01:00)
The following conformation will print:
SERVICE CODE ON HOLD
The above prompt will then reprint.
Restoring The Service Code
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To Restore the Service code, select 2-CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
------ CODES MENU ------
Programming in Menu Mode
57