Changing The Master Code - OSI Security Devices OMNILOCK OM100 Series User Manual

Next, select 5-RESTORE from the Submaster Codes Menu:
-- SUBMASTER CODES MENU
)
---
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
The following prompt will print:
SUBMASTER ID (###)?
Enter the three digit ID number of the Submaster code that you want to
Restore or press the CL key if you are finished restoring Submaster codes .
When you have entered a valid Submaster ID number, confirmation of the
change will print and the above prompt will reprint.

Changing the Master Code

Programming Code Required:
Master Code
As shipped from the factory, the Master code is set to:
For security, you should change the Master Code before using the System.
Write down your new Master code and store it in a sealed envelope
somewhere safe and separate from your list of all other System codes.
The Master code can be as few as four and as many as nine digits long. The
length of the Master code sets the length for all other codes used on the
System.
Programming in Menu Mode
5 01 - 12 34
73