Verifying the Service Code
Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To verify the Service code setting, select 2-CODES from the Main Menu:
)
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 2-SERVICE from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
Next, select 3-VERIFY from the Service Code Menu:
-- SERVICE CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-TIME LIMIT (01:00)
------ CODES MENU ------
Programming in Menu Mode
55