OSI Security Devices OMNILOCK OM100 Series User Manual page 61

Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
Next, select 7-EXTEND from the User Codes Menu:
--- USER CODES MENU ----
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
The following prompt will print:
EXTENDED USER TYPE?
1-SUPERVISOR 2-MANAGER
Select 2-MANAGER
The following prompt will print:
EXTEND USER ID (###)?
Enter the three digit code ID to which you want to assign Manager
privileges (you must enter any leading zeros) or press the CL key if you are
finished assigning Manager privileges. When you have entered a valid ID
number, a confirmation of the change will print and the above prompt will
reprint.
------ CODES MENU ------
1-USER 2-SERVICE 3-AUDIT
Programming in Menu Mode
51