OSI Security Devices OMNILOCK OM100 Series User Manual page 55

Enter the last three digit code ID to which you want to assign extended
group membership, or, if you are only assigning membership for a single
code, press the CL key and the System will accept the starting ID number
that you entered above as the ending ID number. When you have entered a
valid ending ID number, the following prompt will print:
SELECT USER GROUPS
(1-4, 5-ALL, CL-DONE)?
Press the group number for each group for which you wish to extend
membership to the selected code block. If you are assigning membership to
all groups, press 5. When you have finished specifying group numbers,
press the CL key.
If you press the CL key before making any selections, no changes will be
made to the group membership of the specified code block. Otherwise, the
selected group membership will be assigned to the specified code block and
a confirmation of these changes will print. Once completed, the starting ID
prompt will reprint.
Note
The System will not allow you to remove
the
from its assigned membership. (See Setting
Group Boundaries, page 99 for setting
home group boundaries.)
home group of
Programming in Menu Mode
a code
45