OSI Security Devices OMNILOCK OM100 Series User Manual page 47

Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
Next, select 1-ADD from the User Codes Menu:
--- USER CODES MENU ----
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
6-GROUPS 7-EXTEND
If the code length in use on the System is 7, 8 or 9 digits, the following
prompt will print. Otherwise, skip ahead to the next step -- "STARTING
ID".
(1-4)AUTOCODE 5-MANUAL
To have the System automatically generate and assign PINs for you, select
the Facility Autocode number to use (1-4). Each Facility Autocode number
must have been previously programmed before it can be used. (See Setting
The Facility Autocodes, page 102). To add the code PINs manually, select
5-MANUAL. Once you have made your selection, the following prompt
will print:
STARTING ID (###)?
------ CODES MENU ------
Programming in Menu Mode
37