OSI Security Devices OMNILOCK OM100 Series User Manual page 71

To add the Audit code to the System, select 2-CODES from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 3-AUDIT from the Codes Menu:
------ CODES MENU -----
)
1-USER 2-SERVICE 3-AUDIT
4-SUBMASTERS 5-MASTER
Note
A Submaster can not change other Submaster
codes or the Master code, therefore the Codes
Menu appears as shown below when a
Submaster code is used.
1-USER 2-SERVICE 3-AUDIT
Next, select 1-ADD from the Audit Code Menu:
--- AUDIT CODE MENU ---
)
1-ADD 2-REMOVE 3-VERIFY
4-HOLD 5-RESTORE
------ CODES MENU ------
Programming in Menu Mode
61