Indicator Lights; Adding/Changing User Codes - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Command Mode
To program the System, follow these steps:
Step 1 Enter the Master or a Submaster code and begin programming within
the Open Delay Time (as shipped from the factory, the Open Delay
Time is 2 seconds).
Step 2 Enter the desired command sequence.
Step 3 Press and hold the CL key until the lights flash (unless specified
otherwise).
Step 4 Repeat steps 2 and 3 as required.
Step 5 When done, press 000 (the End command) to end your programming
session.
When you Quit your programming session, the green light flashes to
acknowledge the command. The red light flashes immediately afterward to
indicate the end of the programming session and the System will lock unless
the access level is set to Unlocked.

Indicator Lights

By a single flash or through a sequence of flashes, the lights give you the
status of a command that you entered during programming in the Command
Mode.
The green light will flash each time a key is pressed during a programming
session.
A single long green flash after entering a command means your
programming was successful. Typically, two flashes indicate that the System
accepted a Supervisor or higher command or code.
The red light flashes whenever the System does not recognize a command,
or if a parameter is invalid (e.g., Group number 5). Typically, two red
flashes means that the parameter that followed the command is invalid.

Adding/Changing User Codes

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 2-CODES
To assign a new code or change an existing code, enter the following
command sequence while in the Command mode:
22