Setting The Clock - OSI Security Devices OMNILOCK OM100 Series User Manual

A report similar to below will print:
---- STATUS REPORT----
LOCATION #123456 BAT:3
MON 05/29/95
ACCESS: C/R + + + +
OPEN DELAY SECONDS: 02
DAYLIGHT: NORTHERN
SERVICE CODE TIME: 01:00
BATTERY USAGE: 12,176
------------------------
In addition to providing a hard copy printout of the settings of the System,
the Status Report also reports the number of uses on the current set of
batteries (BATTERY USAGE). This counter automatically resets when the
batteries are replaced or if the System is reset to its default values. (See
Resetting The System page 118.)
When the report finishes printing, the Setup Menu will reprint.

Setting the Clock

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 5-SETUP
To set the internal clock of the system, while in Menu Mode, press 5-
SETUP from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
Next, select 2-CLOCK from the Setup Menu:
) ------ SETUP MENU ------
1-STATUS REPORT 2-CLOCK
3-DEFAULTS 4-AUTOCODES
5-RUN DIAGNOSTICS
Programming in Menu Mode
08:26pm
95