Setting Daylight Savings - OSI Security Devices OMNILOCK OM100 Series User Manual

Programming in Menu Mode
Enter the desired Open Delay Seconds from 01 to 30. You must enter any
leading zeros. When you have entered a valid delay time, the Defaults
Menu will reprint and you can then confirm that the new delay time is
shown.
Note
When the Master, a Submaster, a Manager or a
Supervisor code is used, the System remains open
a minimum of 5 seconds to ensure enough time to
begin programming.

Setting Daylight Savings

Programming Code Required:
Master Code, or
Submaster Code with menu privilege 5-SETUP
The System has the ability to automatically adjust its internal clock for
daylight savings time. The four daylight savings time settings are:
Northern: The schedule used in most of North America (first Sunday in
April to last Sunday in October).
Southern: The schedule used in most of the southern hemisphere (last
Sunday in October to first Sunday in March).
European: The schedule used in most of Europe (last Sunday in March to
last Sunday in September).
Manual: For use when none of the above three settings apply. Automatic
time adjustment is disabled and you must set the clock manually for daylight
savings.
To program the Daylight Savings setting, while in Menu Mode, press 5-
SETUP from the Main Menu:
------ MAIN MENU ------
)
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
98