Programming in Menu Mode
Entering the Menu Mode
Turn on the power to the WP4000 Printer and position the Printer above the
System. Enter the Master Code or a Submaster Code (As shipped from the
factory, the Master Code is set to 5 0 1 1 2 3 4 .) The lights will flash to
indicate the battery level (see Batteries, page 105). If locked, the System
will unlock for access. The Printer will print COMMAND # ?. Press 99
within five seconds to begin programming. The "log on" header and the
Main Menu similar to below will print.
OMNILOCK 300 v2.05
(C) OSI SECURITY DEVICES
LOCATION #123456 BAT:3
MON 03/01/99
ACCESS: C/R s + + -
------ MAIN MENU ------
1-AUDIT 2-CODES 3-ACCESS
4-SCHEDULE 5-SETUP 0-END
The log on header displays the following information:
1. The model and firmware version of your System, such as
OMNILOCK 300 v2.05
2. The user programmed location of the System, such as
LOCATION #123456
3.
The current battery status from 3 (new) to 0 (low battery
shutdown), such as BAT: 3
4. The system date and time, such as MON 03/01/99 07:54pm
5. The current access level in affect, such as:
C/R s + + - (Where C/R represents Code Required level and
's + + -' represents the security level of code groups 1
through 4; (s) supervised, (+) enabled/unsupervised, (-)
disabled)
or U/C s + + - (Where U/C represents Unlock with Code
level and 's + + -' represents the group security levels)
32
07:54pm