Dell Force10 S4810P Reference Manual page 95

all
linecard
slot
rpm
booted
file-url
Defaults none
Command Modes EXEC Privilege
Command History
Version 7.7.1.0
E-Series
Usage
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) should be
Information
enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility, this command accepts IPv6
host addresses with or without the square brackets.
A system message appears stating the Bootflash upgrade status. Reload the system to boot
from the upgraded boot images.
After the URL is specified, you can use the same downloaded image for upgrading an individual
RPM, line cards, SFM FPGA, and system-image for cache-boot without specifying the file-url
again using the command upgrade {bootflash-image | bootselector-image |
system-image} {all | linecard linecard-slot | rpm}. After 20 minutes, the
cached memory is released and returned for general use, but the URL is maintained and you do
not have to specify it for subsequent upgrades.
Related
upgrade fpga-image
Commands
boot system
Enter the keyword all to upgrade the bootflash/boot selector image
on all processors in the E-Series. This keyword does not upgrade the
bootflash on the standby RPM.
linecard-
Enter the keyword linecard followed by the slot number to change
the bootflash image on a specific line card. For the E-Series, the
range is 0 to 13 on the E1200, 0 to 6 on the E600, and 0 to 5 on the E300.
Enter the keyword rpm to upgrade the bootflash/boot selector image
on all processors on the RPM.
Enter this keyword booted to upgrade using the image packed with
the currently running FTOS image.
Enter the following location keywords and information to upgrade
using an FTOS image other than the one currently running. Enter the
transfer method and file location:
• flash:
//userid:password@hostip/filepath
• ftp:
• slot0:
• tftp:
decimal address or an IPv6 URI [x:x:x:x::x] format address.
Removed alt-bootflash-image, alt-bootselector-
image, alt-system-image options and the rp1, rp2, and cp
options.
Original command
– upgrades the FPGA version in the specified E-Series SFM.
– displays the configured boot image information.
//filename
//filename
//hostip/filepath where hostip is either an IPv4 dotted
95