Aaa Group Server - Cisco MDS 9124 - Fabric Switch Reference

Chapter 2 A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

aaa group server

To configure one or more independent server groups, use the aaa group server command in
configuration mode. To remove the server group, use the no form of this command to remove the server
group.
Syntax Description
radius
tacacs+
group-name
server server-name
Defaults None.
Command Modes Configuration.
Command History Release
1.3(1)
Usage Guidelines You can configure these server groups at any time but they only take effect when you apply them to a
AAA service using the aaa authentication login or the aaa accounting commands.
Examples
You can configure these server groups at any time but they only take effect when you apply them to a
AAA service using the aaa authentication or the aaa accounting commands.
switch# config terminal
switch(config)# aaa group server tacacs+ TacacsServer1
switch(config-tacacs+)# server ServerA
switch(config-tacacs+)# exit
switch(config)# aaa group server radius RadiusServer19
switch(config-radius)# server ServerB
switch(config-radius)# no server ServerZ
OL-16217-01, Cisco MDS SAN-OS Release 3.x
aaa group server {radius | tacacs+} group-name
server server-name
no server server-name
no aaa group server {radius | tacacs+} group-name
Specifies the RADIUS server group.
Specifies the TACACS+ server group.
Identifies the specified group of servers with a user-defined name. The name
is limited to 64 alphanumeric characters.
Specifies the server name to add or remove from the server group.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
aaa group server
2-9