Cisco MDS 9124 - Fabric Switch Reference page 119

Chapter 1 CLI Overview
Using Debug Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The show logging privileged EXEC command displays the addresses and levels associated with the
current logging setup. The command output also includes ancillary statistics.
Example of Setting Up a UNIX Syslog Daemon
To set up the syslog daemon on a 4.3 BSD UNIX system, include a line such as the following in the file
/etc/syslog.conf:
local7.debugging /usr/adm/logs/tiplog
The local7 keyword specifies the logging facility to be used.
The debugging keyword specifies the syslog level. See Table 1-8 for other keywords that can be listed.
The UNIX system sends messages at or above this level to the specified file, in this case
/usr/adm/logs/tiplog. The file must already exist, and the syslog daemon must have permission to write
to it.
For the System V UNIX systems, the line should read as follows:
local7.debug /usr/admin/logs/cisco.log
Cisco MDS 9000 Family Command Reference
1-45
OL-16217-01, Cisco MDS SAN-OS Release 3.x