Vpc Domain - Cisco Nexus 5000 Series Command Reference Manual

vpc domain

vpc domain
To create a virtual port-channel (vPC) domain, use the vpc domain command. To remove a vPC domain, use
the no form of this command.
vpc domain domain-id
no vpc domain domain-id
Syntax Description
domain-id
Command Default
None
Command Modes
Any command mode
network-admin
Command History
Release
5.2(1)N1(1)
Usage Guidelines
You must enable the vPC feature before you can create a vPC domain.
You put all vPC interfaces, including the vPC peer link, on both of the vPC peer devices into the identical
vPC domain. You must have unique vPC domain numbers within each VDC. Once you create a vPC domain,
the system automatically creates a vPC system MAC address that is unique to that vPC.
You also use this command to enter the vpc-domain command mode in order to configure vPC parameters.
This command does not require a license.
Examples
This example shows how to create a vPC domain:
switch#
config
t switch(config)#
vpc domain
5 switch(config-vpc-domain)#
This example shows how to enter the vpc-domain command mode to configure an existing vPC domain:
switch#
config
t switch(config)#
Cisco Nexus 5000 Series Interfaces Command Reference
184
Domain ID for the vPC . The range of numbers is
from 1 to 1000. You must use unique vPC IDs for
each vPC within a single virtual device context
(VDC).
Modification
This command was introduced.
U and V Commands