Using The No And Default Forms Of Commands; Port Names And Port Mapping - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Navigating Through CLI Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Using the no and Default Forms of Commands

You can issue the no form of any command to perform the following actions:
•
•

Port Names and Port Mapping

The Cisco Fabric Switch for HP c-Class BladeSystem has a different port naming convention from the
Cisco MDS 9000 Family. It has eight external ports and they are labeled ext1 through ext8. It has 16
internal ports and they are labeled bay1 through bay16.
Table 1-5
HP c-Class BladeSystem.
Table 1-5
Cisco MDS 9000 Family Port
fc1/1
fc1/2
fc1/3
fc1/4
fc1/5
fc1/6
fc1/7
fc1/8
fc1/9
fc1/10
fc1/11
fc1/12
fc1/13
Cisco MDS 9000 Family Command Reference
1-14
Undo a wrongly issued command.
If you issue the zone member command, you can undo the results:
switch(config)# zone name test vsan 1
switch(config-zone)# member pwwn 12:12:12:12:12:12:12:12
switch(config-zone)# no member pwwn 12:12:12:12:12:12:12:12
WARNING: Zone is empty. Deleting zone test. Exit the submode.
switch(config-zone)#
Delete a created facility
If you want to delete a zone that you created:
switch(config)# zone name test vsan 1
switch(config-zone)# exit
switch(config)# no zone name test vsan 1
switch(config)#
You cannot delete a zone facility called test while residing in it. You must first exit the zone submode
and return to configuration mode.
shows the port mapping between the Cisco MDS 9000 Family and the Cisco Fabric Switch for
Port Mapping Between the Cisco MDS 9000 Family and the Cisco Fabric Switch for HP
c-Class BladeSystem
Cisco Fabric Switch for HP
c-Class BladeSystem Port
ext8
bay6
bay13
bay5
ext7
bay14
bay15
bay7
bay4
ext1
bay3
bay11
bay12
Chapter 1 CLI Overview
Port Group
PortGroup 1
PortGroup 2
PortGroup 3
PortGroup 4
OL-18089-01, Cisco MDS NX-OS Release 4.x