Remote-Loopback; Symbol-Period - Juniper JUNOS OS 10.3 - SOFTWARE Manual

remote-loopback

Syntax
Hierarchy Level
Release Information
Description
Required Privilege
Level
Related
Documentation

symbol-period

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
remote-loopback;
[edit protocols oam ethernet link-fault-management interface interface-name]
Statement introduced in Junos OS Release 9.4 for EX Series switches.
Set the data terminal equipment (DTE) in loopback mode. Remove the statement from
the configuration to take the DTE out of loopback mode. It is used for IEEE 802.3ah
Operation, Administration, and Maintenance (OAM) link fault management (LFM) support.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Example: Configuring Ethernet OAM Link Fault Management on EX Series Switches
on page 3727
Configuring Ethernet OAM Link Fault Management (CLI Procedure) on page 3729
symbol-period count;
[edit protocols oam ethernet link-fault-management action-profile profile-name; event
link-event-rate] ,
[edit protocols oam ethernet link-fault-management interface interface-name
event-thresholds]
Statement introduced in Junos OS Release 9.4 for EX Series switches.
Configure the threshold for sending symbol period events or taking the action specified
in the action profile.
Symbol code errors occur on the underlying physical layer. The symbol period threshold
is reached when the number of symbol errors reaches the configured value within the
period. You cannot configure the default value to a different value.
count—Threshold count in seconds for symbol period events.
Range: 1 through 100 seconds
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Configuring Ethernet OAM Link Fault Management (CLI Procedure) on page 3729
Chapter 131: Ethernet OAM Link Fault Management
3755