Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3801

Table 494: RPM Probe Owner, Concurrent Probes, and Probe Servers Configuration Fields
Field
Probe Owners
Maximum Number of Concurrent Probes
Copyright © 2010, Juniper Networks, Inc.
when you want information about one-way, rather than round-trip, times for packets to
traverse the network between the requester and the responder.
NOTE:
EX Series switches support hardware timestamps for UDP and ICMP probes.
EX Series switches do not support hardware timestamps for HTTP or TCP
probes.
If the responder does not support hardware timestamps, RPM can only
report the round-trip measurements, it cannot calculate round-trip jitter.
In EX Series switches timestamps apply only to IPv4 traffic.
To configure RPM using the J-Web interface:
Select >
1. Troubleshoot
In the page, enter information as specified in Table 494 on page 3705.
Configure RPM
2.
Click Add to set up the
a.
Select a probe owner from
b.
selected probe owner
Double-click one of the probe owners in
c.
performance probe tests.
Double-click one of the performance probe tests to edit the test parameters.
d.
Enter the
3. Maximum Number of Concurrent Probes
Click to apply the RPM probe settings.
Apply
4.
Function
Identifies a owner for whom one or more
RPM tests are configured. In most
implementations, the owner name
identifies a network on which a set of
tests is being run.
Specifies the maximum number of
concurrent probes allowed.
Chapter 130: Real-Time Performance Monitoring (RPM)
> .
RPM Configure RPM
Owner Name and Performance Probe Tests
list and click
Probe Owners
Probe Owners
Your Action
1.
2. In
3. Click
Type a number from 1 through 500.
.
to remove the
Delete
list to display the list of
and specify the
Probe Servers
Click and type an owner name.
Add
, click
Performance Probe Tests
to define the RPM test parameters.
See Table 495 on page 3706 for
information on configuring RPM test
parameters.
to save the settings or
OK
to exit from the window
Cancel
without saving the changes.
.
Add
3705