Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3854

Complete Software Guide for Junos
Table 499: show oam ethernet link-fault-management Output Fields (continued)
Field Name Field Description
Information about the interface.
Flags
Remote-Stable
satisfaction with local OAM state information.
DTE has either not seen or is unsatisfied with local state information.
indicates that remote DTE has seen and is satisfied with local state
information.
Local-Stable
with remote OAM state information.
not seen or is unsatisfied with remote state information.
local DTE has seen and is satisfied with remote state information.
Remote-State-Valid
information found within Local Information TLVs of received Information
OAM PDUs.
information.
information.
Indicates the remote loopback status. An OAM entity can put its remote peer
Remote loopback
into loopback mode using the Loopback control OAM PDU. In loopback mode,
status
every frame received is transmitted back on the same port (except for OAM
PDUs, which are needed to maintain the OAM session).
Remote entity Remote entity information.
information
Remote MUX action
OAM sublayer. Device is forwarding non-OAM PDUs to the lower sublayer or
discarding non-OAM PDUs.
Remote parser action
sublayer. Device is forwarding non-OAM PDUs to higher sublayer, looping
back non-OAM PDUs to the lower sublayer, or discarding non-OAM PDUs.
Discovery mode
Unidirectional mode
mode for diagnostic purposes.
Remote loopback mode
or not supported.
Link events
supported on the remote peer.
Variable requests
supported. The Variable Request OAM PDU, is used to request one or more
MIB variables from the remote peer.
OAM Receive Statistics
Information The number of information PDUs received.
Event The number of loopback control PDUs received.
Variable request The number of variable request PDUs received.
The number of variable response PDUs received.
Variable response
The number of loopback control PDUs received.
Loopback control
3758
®
OS for EX Series Ethernet Switches, Release 10.3
—Indicates remote OAM client acknowledgment of, and
—Indicates local OAM client acknowledgment of, and satisfaction
False
—Indicates the OAM client has received remote state
False indicates that OAM client has not seen remote state
True indicates that the OAM client has seen remote state
—Indicates the state of the multiplexer functions of the
—Indicates the state of the parser function of the OAM
—Indicates whether discovery mode is active or inactive.
—Indicates the ability to operate a link in a unidirectional
—Indicates whether remote loopback is supported
—Indicates whether interpreting link events is supported or not
—Indicates whether variable requests are supported or not
indicates that remote
False
True
indicates that local DTE either has
True indicates that
Copyright © 2010, Juniper Networks, Inc.
Level of Output
All levels
All levels
All levels
detail
detail
detail
detail
detail