Table 164: Show Service-Management Subscriber-Session Output Fields - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

host1#show service-management subscriber-session 20
User Name: CLIENT50@ISP.COM, Interface: ip192.168.100.33
Id: 20
Owner/Id: CLI
Non-volatile: True
State: Active
ServiceSessions:
Name
-------------------
internet(5000,8000)
Name
------------------
internet(5000,8000)
Table 164 on page 729 lists the show service-management subscriber-session
Meaning
command output fields.

Table 164: show service-management subscriber-session Output Fields

Field Name
Name
Interface
Id
mutex
Owner/Id
State
Non-volatile
Service Sessions
Operation
Service
Activate
Statistics Type
Statistics Complete
mutex Owner State
----- ----- -------------------
12 CLI Config ApplySuccess
Non-volatile
------------
True
Field Description
Name of the subscriber or name of the service session
Type and IP address of the subscriber's interface
ID number of the subscriber session
Index number of the mutex group to which the
service session belongs
Method used to activate the subscriber session (CLI,
AAA) and ID number generated by the owner
(Acct-Session-ID for AAA)
Status of the subscriber session (active or inactive),
or status of the service session
Indicates whether the service session is stored in
NVS; RADIUS-based service sessions are not stored
in NVS
Number of service sessions currently active for this
subscriber
Last operation that Service Manager performed
Name of the service, with parameter values in
parentheses
Indicates whether the last operation was activate
(True) or deactivate (False)
Type of statistics collected; none, time, or
volume-time
Whether statistics have been successfully collected;
True or False
Monitoring Active Subscriber Sessions with Service Manager
Chapter 28: Monitoring Service Manager
Operation
---------
Activate
729