Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 74

JUNOSe 11.1.x Broadband Access Configuration Guide
retransmit
test aaa
NOTE: Specifying the password to associate with the username is optional. Specifying
a virtual router is optional.
timeout
34
Configuring RADIUS Authentication and Accounting Servers
host1(config)#radius update-source-addr 192.168.40.23
Use the no version to delete the parameter so that the router uses the router ID.
See radius update-source-addr
Use to set the maximum number of times (0–100) that the router retransmits a
RADIUS packet to an authentication or accounting server.
If there is no response from the primary RADIUS authentication or accounting
server in the specified number of retries, the client sends the request to the
secondary server. If there is no response from the secondary server, the router
sends the request to the tertiary server, and so on.
Example
host1(config)#radius authentication server 10.10.8.1
host1(config-radius)#retransmit 2
Use the no version to set the value to the default, 3 retransmits.
See retransmit
Use to verify RADIUS authentication and accounting and IP address assignment
setup.
You must specify either a PPP or Multilink PPP (MLPPP) user. PPP indicates a
regular PPP user. MLPPP simulates Multilink PPP so that if multiple test
commands are issued, all test users are bound by the same address.
The command uses a username and password and attempts to authenticate a
user, get an address assignment, and issue a start accounting request.
Optionally, you can specify the virtual router context in which to authenticate
the user.
The command pauses for several seconds, then terminates the session by issuing
a stop accounting request and an address release.
Example
host1#test aaa ppp jsmith mypassword virtual-router charlie2
There is no no version.
See test aaa