Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 242

JUNOSe 11.1.x Broadband Access Configuration Guide
radius calling-station-delimiter
radius include calling-station-id
radius override calling-station-id remote-circuit-id
Related Topics
202
CLI Commands Used to Modify RADIUS Attributes
Use the no version to restore the default Calling-Station-Id format, delimited.
See radius calling-station-format
Use to specify the Calling-Station-Id attribute's delimiter for DSL PPP users.
The delimiter is one special character you select to set off items in the
Calling-Station-Id's definition (for example, # or %).
See radius calling-station-delimiter
Example
host1(config)#radius calling-station-delimiter &
Use the no version to remove the delimiter.
Use to include the Calling-Station-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include calling-station-id acct-start disable
Use the no version to restore the default, enable.
Use to configure RADIUS to override the standard use of the Calling-Station-Id
attribute and instead use the remote circuit ID transmitted from a DSLAM device.
See radius override calling-station-id remote-circuit-id
Example
host1(config)#radius override calling-station-id remote-circuit-id
Use the no version to restore the default Calling-Station-ID value, which is the
telephone number from which the call originated.
Monitoring Override Settings of RADIUS IETF Attributes on page 303
Monitoring the Calling-Station-Id RADIUS Attribute on page 305