Table 136: Show Ip Demux Interface Output Fields; Chapter 26 Monitoring Subscriber Interfaces; Monitoring Subscriber Interfaces Overview - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Chapter 26
Monitoring Subscriber Interfaces

Monitoring Subscriber Interfaces Overview

Purpose
Action
Monitoring Subscriber Interfaces
Purpose
Action
Meaning
This chapter describes how to monitor static and dynamic subscriber interfaces for
remote access to the E Series router. This chapter contains the following sections:
Monitoring Subscriber Interfaces Overview on page 635
Monitoring Subscriber Interfaces on page 635
Monitoring Active IP Subscribers Created by Subscriber Management on page 636
The state of the subscriber interface is determined by state of the Ethernet interface
and the existence of the primary IP interface, which you can monitor with the show
ip interface command. For information about using the show ip interface command,
see the Monitoring IP section in JUNOSe IP Services Configuration Guide .
You can use the show ip demux interface command to monitor the configuration
of subscriber interfaces.
Display information about subscriber interfaces.
To display subscriber interface information:
host1#show ip demux interface fastEthernet 2/0
Prefix/Length SA/DA
10.12.2.2/32 SA
10.12.2.3/32 SA
10.12.2.4/32 SA
10.12.2.5/32 SA
Table 136 on page 635 lists the show ip demux interface command output fields.

Table 136: show ip demux interface Output Fields

Field Name Field Description
Prefix/Length Source or destination addresses that the subscriber interface demultiplexes
Subscriber-Intf VR/VRF
ip subsc1 3
ip subsc2 3
ip subsc3 3
ip subsc4 3
Monitoring Subscriber Interfaces Overview
Description
subsc1@test
subsc2@test
subsc3@test
subsc4@test
635