Nas-Port - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
radius override nas-info
Related Topics

[5] NAS-Port

Use the following commands to manage and display information for the NAS-Port
RADIUS attribute:
NOTE: For subscribers connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS derives a unique value from the subscriber's profileHandle
and uses the value for the Nas-Port attribute. The radius nas-port-format, radius
vlan nas-port-format stacked, and radius pppoe nas-port-format commands do
not affect the value of the Nas-Port attribute.
For more information about subscribers connected over the LAG interface in DHCP
standalone authenticate mode, see "Propagation of LAG Subscriber Information to
AAA and RADIUS" on page 92.
radius include nas-port
192
CLI Commands Used to Modify RADIUS Attributes
Use the no version to restore the default address.
Use in the correct virtual router context to override standard use of
NAS-IP-Address and NAS-Identifier attributes for AAA broadcast accounting;
specifies that the attributes for the authentication virtual router be included in
accounting packets instead of the attributes for the virtual router that generates
the accounting information.
Example
host1(config)#virtual-router vrXyz1
host1:vrXyz1(config)#radius override nas-info
Use the no version to restore standard use of the NAS-IP-Address and
NAS-Identifier attributes.
See radius override nas-info
Monitoring Override Settings of RADIUS IETF Attributes on page 303
radius include nas-port
radius nas-port-format
radius nas-port-format extended
radius pppoe nas-port-format unique
radius vlan nas-port-format stacked