Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 315

Table 50: Juniper Networks (Vendor ID 4874) VSA Formats (continued)
Attribute
Number Attribute Name
[26-143] Max-Clients-Per-Interface
[26-144] PPP-Monitor-Ingress-
Only
[26-147] Backup-Address-Pool
[26-150] ICR-Partition-Id
[26–151] Ipv6-Acct-Input-Octets
[26–152] Ipv6-Acct-Output-Octets
[26–153] Ipv6-Acct-Input-Packets
Description
Maximum number of PPPoE client sessions
supported per interface. For DHCP clients,
this value is the maximum number of
PPPoE sessions per logical interface. For
PPPoE, this value is the maximum number
of PPPoE subinterfaces per a PPPoE major
interface.
See JUNOSe Release Notes, Appendix A,
System Maximums corresponding to your
software release for information about the
maximum number of PPPoE subinterfaces
supported for each line module.
Enable or disable monitoring of only
ingress traffic to determine inactivity of a
PPP session and subsequent disconnection
of an inactive session. If this option is
disabled or not configured, the router
monitors both ingress traffic and egress
traffic to determine session inactivity.
Name of the backup local address pool that
can be used to assign addresses to users
being authenticated by a RADIUS server,
when the existing addresses in the primary
local address pool are fully exhausted.
The authentication server overrides the
backup local address pool name configured
using this attribute with the backup local
address pool name received in the
RADIUS-Access-Accept message.
Used in all the RADIUS authentication and
accounting (Acct-Start, Acct-Stop, and
Interim-Acct messages for both user and
service accounting) messages
corresponding to a subscriber to determine
the partition in which the subscriber has
logged in
Number of times that IPv6 octets have
been received from the port during the
time this service has been provided
Number of times that IPv6 octets have
been sent to the port during the time this
service has been provided
Number of times that IPv6 packets have
been received from the port during the
time this service has been provided to a
framed user
Chapter 6: RADIUS Attribute Descriptions
Subtype
Length Length Value
12 6 integer: 4-octet
12 6 integer:
0 = disable,
1 = enable
len sublen string:
Backup-address-pool-name
len sublen string:icr-partition-id
12 6 4–octet integer
12 6 4–octet integer
12 6 4–octet integer
Juniper Networks VSAs
275