Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 669

interface atm
interface fastEthernet
interface gigabitEthernet
NOTE: You can configure only the primary port, 0, on the Gigabit Ethernet module.
The router automatically uses the redundant port if the primary port fails.
interface tenGigabitEthernet
Use to configure an ATM interface or subinterface type in the slot/port.subinterface
format:
slot Specifies router chassis slot
port Specifies I/O module port
subinterface Specifies subinterface number
Example
host1(config-if)#interface atm 9/1.1
Use the no version to remove the ATM interface or subinterface.
See interface atm
Use to select a Fast Ethernet (FE) interface on a line module or an SRP module.
Example
host1(config)#interface fastEthernet 1/0
Use the no version to remove IP from an interface or subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or a subinterface if the one above it still exists.
See interface fastEthernet
Use to select a Gigabit Ethernet interface.
Example
host1(config)#interface gigabitEthernet 1/0
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or a subinterface
if the one above it still exists.
See interface gigabitEthernet
Use to select a 10-Gigabit Ethernet interface on the E120 router or the E320
router.
Use the slot/adapter/port format.
Chapter 25: Configuring Subscriber Interfaces
Configuring Dynamic Subscriber Interfaces
629