Monitoring Global Configuration Status On E Series Routers - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Table 82: show aaa tunnel-parameters Output Fields (continued)
Related Topics

Monitoring Global Configuration Status on E Series Routers

Display the global configuration and status for L2TP on E Series routers, including
Purpose
switched sessions.
To display the global configuration and status for L2TP on E Series routers, including
Action
switched sessions:
host1#show l2tp
Configuration
Sub-interfaces
Table 83 on page 434 lists the show l2tp command output fields.
Meaning
Field Name
Tunnel calling number format
fallback
show aaa tunnel-parameters
L2TP administrative state is enabled
Dynamic interface destruct timeout is 600 seconds
Data packet checksums are disabled
Receive data sequencing is not ignored
Tunnel switching is disabled
Retransmission retries for established tunnels is 5
Retransmission retries for not-established tunnels is 5
Tunnel idle timeout is 60 seconds
Failover within a preference level is disabled
Weighted load balancing is disabled
Tunnel authentication challenge is enabled
Calling number avp is enabled
Reject remote transmit address change is enabled for ip address
Ignore remote transmit address change is disabled
Disconnect-cause avp generation is enabled
Default receive window size is system chooses
Rx speed avp when equal is enabled
Destination lockout timeout is 300 seconds
Destination lockout test is disabled
Failover resync is silent-failover
total
Destinations 0
Tunnels 0
Sessions 0
Switched-sessions 0
Monitoring Global Configuration Status on E Series Routers
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Fallback format configured for L2TP Calling Number
AVP 22 generated by the LAC
active failed auth-errors
0 0 n/a
0 0 0
0 0 n/a
0 0 n/a
433