Monitoring Configured And Operational Summary Status - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Table 89: show l2tp session Output Fields (continued)
Related Topics

Monitoring Configured and Operational Summary Status

Display a summary of the configured and operational status of all L2TP sessions.
Purpose
To display a summary of the configured and operational status of all L2TP sessions:
Action
host1#show l2tp session summary
Administrative status
Operational status
Meaning
Field Name
SNMP traps
Session status
Effective administrative state
State
Local and peer session id
Statistics
Session operational configuration
show l2tp session
enabled
64
up
64
Table 90 on page 444 lists the show l2tp session summary command output fields.
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Whether or not the router sends traps to Simple
Network Management Protocol (SNMP) for
operational state changes
Session status of the destination
Most restrictive of the following administrative states:
router, destination, tunnel, and session. This setting,
rather than the administrative state of the session,
determines whether the router can maintain this
session or not.
Status of the session: idle, connecting, established,
or disconnecting
Names the router uses to identify the session locally
and remotely
Information about the traffic for this session
Information received from the peer when the session
was created
disabled
0
down lower-down
0 0
Monitoring Configured and Operational Summary Status
not-present
0
443