Table 158: Show Profile Output Fields; Monitoring Ipv4 And Ipv6 Interfaces For Service Manager - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Table 158 on page 713 lists the show profile command output fields.
Meaning

Table 158: show profile Output Fields

Related Topics

Monitoring IPv4 and IPv6 Interfaces for Service Manager

Display status information about the IP and IPv6 interfaces.
Purpose
To display information about a specific IP interface.
Action
host1#show ip interface gigabitEthernet 1/1.200
GigabitEthernet1/1 line protocol Ethernet is up, ip is not present
Field Name
Input Policy
Output Policy
qos-parameter
qos-profile
show profile
Network Protocols: IP
Multipath mode = hashed
Auto Configure = disabled
Auto Detect = disabled
Inactivity Timer = disabled
Use Framed Routes = disabled
ARP spoof checking = disabled
Warm-restart initial-sequence-preference: Operational = 0 Administrative = 0
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
queue 0: traffic class best-effort, bound to ip GigabitEthernet1/1
Queue length 0 bytes
Chapter 28: Monitoring Service Manager
Field Description
Name of input policy and whether statistics are
enabled or disabled
Name of output policy and whether statistics are
enabled or disabled
Name and value of the QoS parameter assigned to
the profile
Name of the QoS profile assigned to the profile
Monitoring IPv4 and IPv6 Interfaces for Service Manager
713