Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 668

JUNOSe 11.1.x Broadband Access Configuration Guide
atm pvc
default-router
encapsulation bridge1483
encapsulation vlan
628
Configuring Dynamic Subscriber Interfaces
Use to configure a PVC on an ATM interface.
Specify the VCD, the VPI, the VCI, and the encapsulation type. (For more
information about these parameters, see the Creating a Basic Configuration section
in JUNOSe Link Layer Configuration Guide .)
Example
host1(config-subif)#atm pvc 10 100 22 aal5snap
Use the no version to remove the specified PVC.
See atm pvc
Use to specify the IP address of the router for the subscriber's computer to use
for traffic destined for locations beyond the local subnet.
Specify the IP address of a primary server, and optionally, specify the IP address
of a secondary server.
Example
host1(config-dhcp-local)#default-router 10.10.1.1
Use the no version to remove the association between the address pool and the
router.
See default-router
Use to configure bridged Ethernet as the encapsulation method on an interface.
Example
host1(config-subif)#encapsulation bridge1483
Use the no version to remove bridged Ethernet as the encapsulation method on
the interface.
See encapsulation bridge1483
Use to configure VLAN as the encapsulation method on an interface.
Issuing this command creates the VLAN major interface.
Example
host1(config-if)#encapsulation vlan
Use the no version to disable VLAN encapsulation on the interface.
See encapsulation vlan