Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 302

JUNOSe 11.1.x Broadband Access Configuration Guide
Table 49: RADIUS IETF Attributes Supported by JUNOSe Software (continued)
Attribute
Number Attribute Name
[46] Acct-Session-Time
[47] Acct-Input-Packets
[48] Acct-Output-Packets
[49] Acct-Terminate-Cause
[50] Acct-Multi-Session-Id
[51] Acct-Link-Count
[52] Acct-Input-Gigawords
262
RADIUS IETF Attributes
Description
Indicates how long in seconds that the user has received service
Indicates how many packets have been received from the port during the
time this service has been provided to a framed user
IP subscriber manager Statistics are reported
PPP Statistics are counted according to the rules of the generic interface
MIB
Indicates how many packets have been sent to the port in the course of
delivering this service to a framed user
IP subscriber manager Statistics are reported
PPP Statistics are counted according to the rules of the generic interface
MIB
Contains the reason the service (a PPP session) was terminated. The service can
be terminated for the following reasons:
User Request (1) User initiated the disconnect (log out)
Idle Timeout (4) Idle timer has expired
Session Timeout (5) Client reached the maximum continuous time allowed
on the service or session
Admin Reset (6) System administrator terminated the session
Port Error (8) PVC failed; no hardware or no interface
NAS Error (9) Negotiation failures, connection failures, or address lease
expiration
NAS Request (10) PPP challenge timeout, PPP request timeout, tunnel
establishment failure, PPP bundle failure, IP address lease expiration, PPP
keep-alive failure, Tunnel disconnect, or an unaccounted-for error
String constructed from the Acct-Session-ID of the first PPP link established
for the Multilink PPP bundle and the internal Multilink PPP bundle ID.
This string is the hexidecimal ASCII characters for two 4-octet unsigned
integers. Example: 0a34331200001249.
A value that increments with each link that joins the MLPPP bundle. This attribute
does not indicate the number of active links. For more details, see RFC
2866 RADIUS Accounting (June 2000).
Indicates how many times the Acct-Input-Octets counter has wrapped around
2^32 during the time this service has been provided, and can be present in
Accounting-Request records only where the Acct-Status-Type is set to Stop or
Interim-Update
IP subscriber manager Statistics are reported
PPP Statistics are counted according to the rules of the generic interface
MIB