Table of Contents
Advertisement
JUNOSe 11.1.x Broadband Access Configuration Guide
Table 83: show l2tp Output Fields
434
Monitoring Global Configuration Status on E Series Routers
Field Name
Configuration
L2TP administrative state
Dynamic interface destruct
timeout
Data packet checksums
Receive data sequencing
Tunnel switching
Retransmission retries for
established tunnels
Retransmission retries for
not-established tunnels
Tunnel idle timeout
Failover within a preference level
Weighted load balancing
Tunnel authentication challenge
Calling number avp
Reject remote transmit address
change
Ignore remote transmit address
change
Disconnect-cause avp generation
Default receive window size
Rx speed avp when equal
Destination lockout timeout
Destination lockout test
Field Description
Configuration and status for L2TP on E Series routers,
including switched sessions
Status of L2TP on the router; enabled or disabled
Number of seconds that the router maintains dynamic
destinations, tunnels, and sessions after they have
terminated
Status of checking data integrity via UDP; enabled or
disabled
Whether the router processes or ignores sequence
numbers in incoming data packets
Enabled or disabled
Number of retries configured for established tunnels
Number of retries configured for tunnels not
established
Length of the tunnel idle timeout, in seconds
Enabled or disabled
Enabled or disabled
Enabled or disabled
Whether the E Series LAC sends Calling-Station-Id
and Called-Station-Id AVPs in ICRQ packets, enabled
or disabled
Enabled or disabled for IP address, UDP port, or both
Enabled or disabled for IP address, UDP port, or both
Enabled or disabled
Default L2TP RWS for a tunnel on both the LAC and
the LNS; displays either the configured value or the
default behavior, indicated by system chooses
Enabled or disabled
Number of seconds that L2TP destinations remain in
the lockout state after they become unavailable
Status of the L2TP destination lockout test, enabled
or disabled
Advertisement
Table of Contents
Troubleshooting
