Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 238

JUNOSe 11.1.x Broadband Access Configuration Guide
NOTE: For subscribers connected over the LAG interface in DHCP standalone
authenticate mode, The radius override calling-station-id remote-circuit-id
command enables RADIUS to use the PPPoE remote circuit ID for the Calling-Station-Id
attribute. By default, RADIUS uses a delimited format for the interface description.
The radius calling-station-format command does not affect the value of the
Calling-Station-Id attribute.
For more information about subscribers connected over the LAG interface in DHCP
standalone authenticate mode, see "Propagation of LAG Subscriber Information to
AAA and RADIUS" on page 92.
radius calling-station-format
198
CLI Commands Used to Modify RADIUS Attributes
Use to specify the format of the Calling-Station-Id [31] attribute on a virtual
router.
For each field in angle brackets (<>) in the Calling-Station-Id formats, the virtual
router supplies the actual value for your configuration, unless otherwise specified.
To specify that the RADIUS client use the delimited format when the PPP user
is terminated at the non-LNS E Series router, use the delimited keyword.
Format for ATM interfaces:
<delimiter> <system name> <delimiter> <interface> <delimiter>
<VPI> <delimiter> <VCI><delimiter>
Format for Ethernet interfaces:
<delimiter> <system name> <delimiter> <interface> <delimiter>
<VLAN>
Where <interface> is one of the following items:
<port name> The default setting
<VP description> Appears if you use the atm vp-description command
to assign a text description to an individual VP on an ATM interface
<VC description> Appears if you use the atm atm1483 description
command to assign a text description to VCs on an ATM 1483 subinterface
and you use the atm1483 export-subinterface-description command to
enable sending of VC interface descriptors to AAA
To specify that the RADIUS client use a fixed format of up to 15 characters
consisting of all ASCII fields, use the fixed-format keyword. The maximum
number of characters for each field is shown in square brackets ([ ]).
Format for ATM interfaces:
<system name [4]> <slot [2]> <port [1]> <VPI [3]> <VCI [5]>
Format for Ethernet interfaces:
<system name [4]> <slot [2]> <port [1]> <VLAN [8]>
Format for serial interfaces:
<system name [4]> <slot [2]> <port [1]> <0 [8]>