Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 300

JUNOSe 11.1.x Broadband Access Configuration Guide
Table 49: RADIUS IETF Attributes Supported by JUNOSe Software (continued)
Attribute
Number Attribute Name
[5] NAS-Port
[6] Service-Type
[7] Framed-Protocol
[8] Framed-IP-Address
[9] Framed-IP-Netmask
[11] Filter-Id
[12] Framed-MTU
[13] Framed-Compression
[18] Reply-Message
[22] Framed-Route
[24] State
[25] Class
[26] Vendor-Specific
260
RADIUS IETF Attributes
Description
Physical port number of the NAS that is authenticating the user
See the radius nas-port-format, radius pppoe nas-port-format unique,
and radius vlan nas-port-format stacked commands in "Configuring RADIUS
Attributes" on page 171.
Type of service the user has requested or the type of service to be provided
Admin, Login, NAS Prompt, or Framed only
Framing protocol used for framed access
Standard value of 1 set for PPP
Nonstandard value of 1008 set for dynamic ATM
IP address to be configured for the user
0.0.0.0 or absence is interpreted as 255.255.255.254
See the radius include framed-ip-add acct-start command in "Configuring
RADIUS Attributes" on page 171.
IP network to be configured for the user when the user is a router to a network
Absence implies 255.255.255.255
Name of the filter list for the user
Interpreted as input policy name
The maximum transmission unit to be configured for the user, when it is not
negotiated by some other means (such as PPP).
When sent in an Access-Request with an EAP-Message, indicates the maximum
size of the EAP-Message string that the external server supports.
Always set to none.
Text that may be displayed to the user
Only the first instance of this attribute is used
String that provides routing information to be configured for the user on the NAS;
in the format:
<addr>[/<maskLen>] [<nexthop> [<cost>]] [tag <tagValue>] [distance
<distValue>]
An arbitrary value that the router includes in new Access-Request packets
from the previous Accept-Challenge
Applicable for CLI, telnet, or EAP message exchange
An arbitrary value that the NAS includes in all accounting packets for the user if
supplied by the RADIUS server
Juniper Networks Enterprise number 0x0000130A