Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 460

JUNOSe 11.1.x Broadband Access Configuration Guide
l2tp dial-out connecting-timer-value
l2tp dial-out dormant-timer-value
l2tp dial-out max-buffered-triggers
420
Configuring L2TP Dial-Out
Reset a dial-out session by forcing it to the dormant state.
host1#l2tp dial-out session reset 10.10.0.0
Use to set the maximum time allowed for attempts to establish L2TP dial-out
sessions.
If the session fails to be established before the connecting timer expires,
subsequent attempts to establish the dial-out session to the same destination
are inhibited temporarily.
The range is 30–3600 seconds.
Example
host1(config)#l2tp dial-out connecting-timer-value 30
Use the no version to set the connecting timer to the default, 30 seconds.
See l2tp dial-out connecting-timer-value
Use to set how long the dial-out session waits in the dormant state for a new
trigger after the associated L2TP outgoing call ends.
If no trigger is received before the dormant timer expires, the dial-out session
is deleted.
The range is 0–3600 seconds.
Example
host1(config)#l2tp dial-out dormant-timer-value 300
Use the no version to set the dormant timer to the default, 300 seconds (5
minutes).
See l2tp dial-out dormant-timer-value
Use to set the maximum number of buffered trigger packets held for any dial-out
session pending the successful establishment of the L2TP session. Once the
session is established, the buffered trigger packets are transmitted.
Trigger packets received when the maximum number of triggers are already
buffered are discarded.
The range of values is 0–50.
Example
host1(config)#l2tp dial-out max-buffered-triggers 50
Use the no version to set the number of trigger buffers to the default, 0.
See l2tp dial-out max-buffered-triggers