Ignoring Attributes When Receiving Access-Accept Messages - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Related Topics

Ignoring Attributes When Receiving Access-Accept Messages

You can configure the router to ignore or use many attributes that it receives in
Access-Accept messages.
radius ignore
Related Topics
Use to enable or disable the inclusion of RADIUS attributes in Acct-On, Acct-Off,
Access-Request, Acct-Start, and Acct-Stop messages.
Examples
host1(config)#radius include ingress-policy-name acct-start enable
host1(config)#radius include tunnel-type access-request disable
Use the no version to restore the default, disable.
See radius include
To see a list of the attributes that you can include or exclude, see Monitoring
Included RADIUS Attributes on page 308
Use to specify that a RADIUS attribute be ignored or be accepted from
Access-Accept messages.
Use the enable keyword to specify that the RADIUS client ignore the attribute
from the RADIUS server or the disable keyword to use the attribute.
Examples
host1(config)#radius ignore atm-scr enable
host1(config)#radius ignore framed-ip-netmask disable
Use the no version to restore the default, enable.
See radius include
To see the list of attributes that the router uses or ignores, see Monitoring Ignored
RADIUS Attributes on page 310
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
239