Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 301

Table 49: RADIUS IETF Attributes Supported by JUNOSe Software (continued)
Attribute
Number Attribute Name
[27] Session-Timeout
[28] Idle-Timeout
[30] Called-Station-Id
[31] Calling-Station-Id
[32] NAS-Identifier
[33] Proxy-State
[40] Acct-Status-Type
[41] Acct-Delay-Time
[42] Acct-Input-Octets
[43] Acct-Output-Octets
[44] Acct-Session-Id
[45] Acct-Authentic
Description
Maximum number of consecutive seconds of service to be provided to the user
before termination of the session
Maximum number of consecutive seconds of idle connection provided to the user
before termination of the session
Allows the NAS to send the phone number that the user called
Not supported for nontunneled or LAC session side
For the LNS, the format is the string passed in the Called Number AVP
For RADIUS relay server, indicates the subscriber's wireless access point
Allows the NAS to send the phone number from which the call originated
See the radius calling-station-format and the radius
calling-station-delimiter commands in "Configuring RADIUS Attributes" on
page 171.
For RADIUS relay server, indicates the subscriber's MAC address
Identifies the NAS originating the request
System-wide configurable hostname or VR-sensitive configurable NAS-identifier
name
E Series router's port ID and IP address
Indicates whether this Accounting-Request marks the beginning of the user service
(Start), the end (Stop), or the interim (Interim-Update)
Indicates how many seconds the client has been trying to send a particular record
Indicates how many octets have been received from the port during the time
this service has been provided
IP subscriber manager Statistics are reported
PPP Statistics are counted according to the rules of the generic interface
MIB
Indicates how many octets have been sent to the port during the time this
service has been provided
IP subscriber manager Statistics are reported
PPP Statistics are counted according to the rules of the generic interface
MIB
Unique accounting identifier that makes it easy to match start and stop records
in a log file
See the radius acct-session-id-format and the radius include acct-session-id
access-request commands in "Configuring RADIUS Attributes" on page 171.
Indicates how the user was authenticated: whether by RADIUS, the NAS itself,
or another remote authentication protocol
Always 1
Chapter 6: RADIUS Attribute Descriptions
RADIUS IETF Attributes
261