[55] Event-Timestamp; [61] Nas-Port-Type - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

[55] Event-Timestamp

Use the following command to manage the Acct-Output-Gigawords RADIUS attribute.
radius include event-timestamp

[61] NAS-Port-Type

Use the following commands to manage and display information for the
NAS-Port-Type RADIUS attribute.
NOTE: For subscribers connected over the LAG interface in DHCP standalone
authenticate mode, RADIUS calculates the value of the Nas-Port-Type attribute.
For more information about subscribers connected over the LAG interface in DHCP
standalone authenticate mode, see "Propagation of LAG Subscriber Information to
AAA and RADIUS" on page 92.
radius dsl-port-type
host1(config)#radius include output-gigawords acct-stop enable
Use the no version to restore the default, enable.
radius include event-timestamp
Use to include the Event-Timestamp attribute in Acct-Start, Acct-Stop, Acct-On,
or Acct-Off messages.
You can control inclusion of the Event-Timestamp attribute by enabling or
disabling this command.
See radius include
Example
host1(config)#radius include event-timestamp acct-on enable
Use the no version to restore the default, enable.
radius dsl-port-type
radius ethernet-port-type
radius include nas-port-type
Use to configure the NAS-Port-Type attribute for the DSL port type.
This attribute can have several values. If the interface (port) is DSL, then the
attribute can have any value listed in the command and uses the value configured.
If the interface (port) is Ethernet, then it sets the attribute to Ethernet and
disregards the parameter set with this command. Options include:
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
209