Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 289

NOTE: The function of this command has been replaced by a combination of the
RADIUS dynamic-request server feature and the subscriber disconnect command.
This command might be removed completely in a future release.
radius dynamic-request server
subscriber disconnect
NOTE: This command and the RADIUS dynamic-request server feature replace the
radius disconnect client command, which may be removed completely in a future
release. The RADIUS Disconnect Configuration mode is also deprecated.
udp-port
Use the no version to remove the RADIUS disconnect client.
See radius disconnect client
Use to configure a RADIUS dynamic-request server and enter RADIUS
Configuration mode. Specify the IP address of the RADIUS server that exchanges
messages with the RADIUS dynamic-request server.
Example
host1(config)#radius dynamic-request server 10.10.5.10
host1(config-radius)#
Use the no version to unconfigure the RADIUS dynamic-request server.
See radius dynamic-request server
Use to enable the RADIUS dynamic-request server to receive RADIUS disconnect
messages from a RADIUS server.
Example
host1(config-radius)#subscriber disconnect
Use the no version to disable processing of disconnect packets.
See subscriber disconnect
Use to specify the UDP port on which the RADIUS dynamic-request server listens
to receive messages from the RADIUS server.
Example
host1(config-radius)#udp-port 1770
Use the no version to return to the default, port 1700.
See udp-port
Chapter 4: Configuring RADIUS Dynamic-Request Server
RADIUS Dynamic-Request Server Commands
249