Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 79

radius trap auth-server-responding
radius trap no-acct-server-responding
radius trap no-auth-server-responding
Use to enable or disable SNMP traps when a RADIUS authentication server fails
to respond to a RADIUS Access-Request message.
The associated SNMP object is rsRadiusClientTrapOnAuthServerUnavailable.
Example
host1(config)#radius trap auth-server-not-responding enable
Use the no version to return to the default setting, disabled.
See radius trap auth-server-not-responding
Use to enable RADIUS to send SNMP traps when a RADIUS authentication server
returns to service after being marked as unavailable.
The associated SNMP object is rsRadiusClientTrapOnAuthServerAvailable.
This command affects only the current VR context.
Example
host1(config)#radius trap auth-server-responding enable
Use the no version to restore the default setting, disabled.
See radius trap auth-server-responding
Use to enable or disable SNMP traps when all of the configured RADIUS
accounting servers per VR fail to respond to a RADIUS accounting request.
The associated SNMP object is rsRadiusClientTrapOnNoAcctServerAvailable.
Example
host1(config)#radius trap no-acct-server-responding enable
Use the no version to return to the default setting, disabled.
See radius trap no-acct-server-responding
Use to enable or disable SNMP traps when all of the configured RADIUS
authentication servers per VR fail to respond to a RADIUS Access-Request
message.
The associated SNMP object is rsRadiusClientTrapOnNoAuthServerAvailable.
Example
host1(config)#radius trap no-auth-server-responding enable
Use the no version to return to the default setting, disabled.
See radius trap no-auth-server-responding
Configuring RADIUS Authentication and Accounting Servers
Chapter 1: Configuring Remote Access
39