Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 108

JUNOSe 11.1.x Broadband Access Configuration Guide
ppp aaa-profile
NOTE: Although an AAA profile and an interface profile have similar functionality,
they are not related and should be treated differently.
translate
68
Configuring AAA Profiles
Use the no version to negate the command.
See deny
Use to assign an AAA profile to static and dynamic, multilink and nonmultilink
PPP interfaces.
The PPP application associates the AAA profile with the interface and passes the
AAA profile to AAA for authentication.
If an AAA profile is deleted after it has been assigned to an interface, AAA will
deny the authentication and log a message.
When you remove an AAA profile, it does not remove any corresponding bindings
between PPP interfaces or interface profiles and the AAA profile. If an AAA profile
with the same name is added, the interface cannot authenticate until the AAA
profile is reassigned.
Example
host1(config-if)#ppp aaa-profile westford24
Use the no version to remove the AAA profile assignment.
See ppp aaa-profile
Use to map the original domain name to the mapped domain name for domain
map lookup.
This command allows you to group multiple domain names into a single domain
name (that is, to use aliases).
You can use this command to partition PPP subscribers with the same domain
into separate domains, based on the PPP interface. By doing this, you do not
cause modification of the user's name or domain.
Example
host1(config-aaa-profile)#translate abc.com xyz.com
Use the no version to negate the command.
See translate