Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 338

JUNOSe 11.1.x Broadband Access Configuration Guide
Table 55: Default PPP Mappings (continued)
298
PPP Terminate Reasons
PPP Terminate Reason
ipv6 peer terminate term req
ipv6 service disable
ipv6 stale stacking
lcp authenticate terminate hold
lcp configured mrru too small
lcp configured mru invalid
lcp configured mru too small
lcp dynamic interface hold
lcp keepalive failure
lcp loopback rx conf req
lcp loopback rx echo reply
lcp loopback rx echo req
lcp max configure exceeded
lcp mru changed
lcp negotiation timeout
lcp no localaccm
lcp no localacfc
lcp no local authentication
lcp no local endpoint discriminator
lcp no local magic number
lcp no local mrru
lcp no local mru
lcp no localpfc
lcp no peer accm
lcp no peer authentication
lcp no peer endpoint discriminator
RADIUS Acct-Terminate-Cause
Code Description
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request
10 nas request