Service Interim Accounting For Ipv4 And Ipv6 Services In A Dual Stack Overview - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
NOTE: To enable interim service accounting, the service accounting interval must
be set to a non-zero value and the service statistics type must not be set to none.
aaa user accounting interval

Service Interim Accounting for IPv4 and IPv6 Services in a Dual Stack Overview

You can query the external parent group statistics similar to the statistics retrieved
for classifier lists. You must specify the correct external parent group name and its
corresponding hierarchical policy parameter for each of the input, output, and
secondary-input statistics. You can specify a list of external parent groups along with
hierarchical policy parameter for which statistics must be collected and sent to Service
Manager for display in the Acct-Stop and Interim-Acct messages. The statistics for
packets arriving at an interface attached at the input stage and the statistics for
packets arriving at an interface attached at the secondary input stage are added and
displayed in the Input Bytes field of the show service-management command. The
statistics for packets leaving an interface at which the hierarchical policy is defined
are displayed in the Output Bytes field of the show service-management command.
The external parent group statistics are not limited to combined IPv4 and IPv6 services
676
Configuring RADIUS Accounting for Service Manager
Example
host1(config)#aaa service accounting interval 60
Use the no version to reset the accounting interval to 0, which turns off interim
service accounting when no value is specified in the Service-Interim-Acct-Interval
attribute (Juniper VSA 26-140).
See aaa service accounting interval
Use to specify the default interval between user accounting updates. The router
uses the default interval when no value is specified in the RADIUS
Acct-Interim-Interval attribute (RADIUS attribute 85).
This command and the aaa service accounting interval command replace the
aaa accounting interval command, which is deprecated and might be removed
in a future release.
The default interval is applied on a virtual router basis this setting is used for
all users who attach to the corresponding virtual router.
Specify the user accounting interval, in the range 10–1440 minutes. The default
setting is 0, which disables the feature.
Example
host1(config)#aaa user accounting interval 20
Use the no version to reset the accounting interval to 0, which turns off interim
user accounting when no value is specified in the RADIUS Acct-Interim-Interval
attribute.
See aaa user accounting interval