Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual page 402

JUNOSe 11.1.x Broadband Access Configuration Guide
19.
20.
host1(config)# show aaa domain-map
Domain: westford.com; router-name: default; ipv6-router-name: default
Tunnel Tunnel Tunnel
Tag Peer Source
------ ------------ -----------
3 192.168.2.13 192.168.3.3
Tunnel
Tunnel Server Tunnel
Tag Name Preference
------ ------ ----------
3 boston 5
host1#show aaa tunnel-parameters
Tunnel password is 3&92k%b#q4
Tunnel client-name is <NULL>
Tunnel nas-port-method is none
Tunnel nas-port ignore disabled
Tunnel nas-port-type ignore disabled
Tunnel assignmentId format is assignmentId
Tunnel calling number format is descriptive
Related Topics
362
Mapping User Domain Names to L2TP Tunnels from Domain Map Tunnel Mode
(Optional) Disable the generation of authentication challenges by the local tunnel,
so that the tunnel does not send a challenge during negotiation. However, the
tunnel does accept and respond to challenges it receives from the peer.
host1(config)#l2tp disable challenge
Verify the L2TP tunnel configuration.
Tunnel Tunnel
Type Medium
------ ------
l2tp ipv4
Tunnel
Max
Sessions Tunnel RWS
-------- --------------
0 system chooses
Mapping User Domain Names to L2TP Tunnels from Tunnel Group Tunnel Mode
on page 363
aaa domain-map
aaa tunnel assignment-id-format
aaa tunnel client-name
aaa tunnel ignore
aaa tunnel password
address
client-name command
identification command
l2tp disable challenge
l2tp ignore-receive-data-sequencing
medium ipv4 command
password command
preference command
router-name
Tunnel
Tunnel Tunnel Client
Password Id Name
--------- ------ ------
temporary acton host4
Tunnel
Virtual
Router
-------
vr2